next audiocom MAVERICK MV10, User Manual, Page: 9 / 12

6
www.nextaudiocom.com
SERVICE
REMOTE CONTROL
1 - Pair Bluetooth Audio Device
2 - Pair MV10 in TWS mode (Stereo Bluetooth)
3 - Increase Volume Level
4 - Previous Track
5 - Play / Pause
6 - Next Track
7 - Decrease Volume Level
8 - Folder Selection
9 - Folder Selection
10 - Playback Loop
TROUBLESHOOTING
BATTERY REPLACEMENT
1. Switch the speaker OFF. Unscrew the four screws at the bottom of the speaker.
2. Unplug the connector, remove and replace the battery, re-connect the plug.
3. Install the bottom cover and secure it with the four screws.
All LED OFF on the amplifier panel
Speaker is ON but no sound
No sound from microphone
Sound distorting - peak LED ON most of time
Sound distorting - peak LED OFF
Skipping or stuttering playback with streaming
audio
Paired device is too far from the speaker Move the device closer to the speaker
Acoustic feedback from the microphone Microphone is in front or too close to the MV6 Avoid being in front or too close to the speaker
Intermittent output - cracking or distortion Faulty signal connection Check and / or replace signal cables
Mixer / audio source is overdriven Reduce level from source / Raise level on MV10
Excessive sound level at the input channel Reduce the level knob - counterclockwise
Condenser microphone - needs phantom power
Switch to a dynamic microphone or use external
phantom power for condenser microphones
Signal source not sending / faulty signal cables Verify the audio is playing / replace signal cables
AC Cable not connected / Battery discharged Verify the IEC cable / Charge the battery
Symptom Possible cause Action
1
2
3
5
8
6
7
9