25
3. Remove the wire connector from the LED light set.
4. Gently pull the old LED light from the wire connector.
5. Insert a new LED light into the wire connector.
6. Turn the power on and test the LED lights to ensure they are working properly.
7. Push LED light set back into position inside the hood body. Ensure
the clips on either side of the light set are fully secured before
releasing the light set.
h. Trouble shooTing
1. If the range hood does not operate after installation:
- Check if all power has been turned back on and all electrical wiring
is properly connected.
- Check that the power connection for the unit is properly connected.
- Make sure the wiring between the switch board and control board
are connected properly.
2. The range hood vibrates when the blower is on:
- The range hood might not have been secured properly to the wall.
- Check if the motor is secured in place. If not, then tighten the motor
in place.
- Check if there is a damaged blower wheel. If so change the blower
wheel.
3. The blowers seems weak:
- Check that the duct size used is at least 15.2 cm (6 in.). Range hood
WILL NOT function efficiently with insufficient duct size. For example:
17.8 cm (7 in.) duct cover 15.2 cm (6in.) holes and loosely secured.
- Check if duct is clogged or if damper unit is not opening properly. A
tight mesh on a side wall cap unit might also restrict air flow.
WARNING
ELECTRICAL SHOCK HAZARD
Do not perform service on an electrically live system.
Disconnect the main electrical supply before servicing
this device. Touching electrical connectors or other
exposed electrical circuitry inside this range hood
when they are energized could result in death, serious
bodily injury, or property damage.
