Prepare the mounting rails
CAUTION
: Ensure that your rack can support the total weight of all mounted components and that
your floor is sufficiently strong.
Note
As the Nexsan Storage System is a fixed-in-rack design, cable management arms are not required.
The rails are labeled “L” (left) and “R” (right) on the outside surfaces, as shown in
. When installing
them into the rack, be sure to place them on the correct sides.
Figure 3-1: Mounting rails’ “left” and “right” labeling
►
To prepare the mounting rails for Nexsan Storage System installation:
1. Extend the slides to fit your rack.
Note
The rails can be adjusted to between 26" (66cm) and 36" (91.4cm).
Figure 3-2: Extending the rack-mount rails
Prepare the mounting rails
28
Part Number: P0450138, Rev. B
Nexsan BEAST™ and E-Series™
3