Copyright © 2017 NEXCOM International Co., Ltd. All Rights Reserved.
40
NDiS B866 User Manual
Chapter 4: BIOS Setup
PCH-IO Configuration
This section is used to configure PCH-IO configuration.
PCH LAN Controller
Enables or disables onboard NIC.
Serial IRQ Mode
Configures the serial IRQ mode.
State After G3
Configures the power state when power is re-applied after a power failure
(G3 state).
Chipset
Version 2.18.1263. Copyright (C) 2018 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2018 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
SB Porting Configuration
PCH-IO Configuration
SB Porting Configuration
PCH LAN Controller
Serial IRQ Mode
State After G3
[Enabled]
[Continuous]
[S0 State]
►
Security
Save & Exit
Advanced
Chipset
Security
Boot
Main
Version 2.18.1263. Copyright (C) 2018 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2018 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Set Administrator Password
Password Description
If ONLY the Administrator’s password is set,
then this only limits access to Setup and is
only asked for when entering Setup.
If ONLY the User’s password is set, then this
is a power on password and must be entered to
boot or enter Setup. In Setup the User will
have Administrator rights.
The password length must be
in the following range:
Minimum length
3
Maximum length
20
Administrator Password
User Password
Administrator Password
Select this to reconfigure the administrator’s password.
User Password
Select this to reconfigure the user’s password.
