Nexcom EBC 500 Series, User Manual

Page: 9 / 35

EBC 500 User’s Manual 9 Chapter 1
Extra (External) LED: 2 x 4 pin header
*Audio
AC97 Audio CODEC
Realtek RTL655 CODEC for AC97 v2.1 CODEC
Line in with pin header
Microphone in and Speaker out Interface
* I/O Interface
USB 2.0
6 x USB 2.0 port (2 on front, 4 on Board by one 2.0 mm JST
Connectors), bandwidth: 480 Mb/s
Serial ports
SIO
×
4, support RS-232 with pin headers
1 x3-pin jumper to switch 5V and 12V power source
Parallel ports 1 x Box header 26-pin connector
PS/2 1 x PS/2 connector for Keyboard and Mouse
GPIO
8 GPIO lines via header (GPI 0~3 and GPO 0~3); GPO0 and GPO1
could be connected to LED for programmable feature
TTL Level (0/5V)
FAN
1x 4-pin FAN JST connector (for CPU)
2x 3-pin FAN connector x 2 (for System)
IrDA On board pin header for IrDA Tx Rx
Others
On Board buzzer
Power LED/HDD Power LED
SMBus 2.0 controller (2 pin header)
On board 2 pin header for reset (for power on button switch)
On-board RTC
On-chip RTC with battery back up
External Lithium battery x 1
RTC Tolerance less than 2sec (24 hours) under 25˚C environment
*Storage Support
CF
1x Internal CompactFlash socket
Support One Type I& II Compact Flash Card (Primary Master)
SATA 2 x SATA ports, support Raid 0,1, bandwidth: 150 MB/s
IDE 1 x 44-pin IDE connector
Disk on Module 1 x 2-pin Jst power (+5V,GND ) for DOM
*Power Supply
Type
Support both AT and ATX Mode
Factory default setting is AT mode
ATX mode
+5V / -5V / 5Vsb Power In (+12V/-12V for PC 104 plus)
When Change to ATX Mode, the BIOS default setting is as follow:
POWER -SUPPLY TYPE [ATX]
AUTO PWR-FAILURE RESUME [ON]
AT mode
+5V Power in
No Power On push Button, Software Shutdown function and LAN remote
wake up
Power consumption 43.2 W in 12V, 121.2 W in 5V, and 11.5W in 5Vsb
Drivers
Windows 2000/2003, XP, Linux
*Environment
Operating Temperature 0
°
C ~ 60
°
C
Storage Temperature -20˚C to 85˚C
Relative Humidity
Operating 10%~90%, non-condensing
Non-operating 5%~95%, non-condensing
* Certifications
CE approval
FCC Class A