background image

current wiring at home.
Single AC Live-in / Neutral-in

Twin AC Live-in / Neutral-in

Programming
The receiver module can pair with up to 6 different remote controls at any one time 
as it has a maximum of 6 memories. 
This receiver cannot be controlled by “Code Switch System” remote transmitters.
Only compatible with “Self Learning System” remote transmitters. / Self learning 
transmitters and Nexa Gateway.
Programming using LEARNING MODE:
On the receiver module press the ‘Learn’ button once, red LED with flash. It is 
now in learning mode.

Using a remote control press the ‘ON’ button intended to be paired; the load/light 
will flash twice to confirm that the remote control is now paired. 

NOTE: Learning Mode lasts for 12 seconds; if no signal is received from a remote 
control during this time then the receiver module will automatically exit learning 
mode without pairing the device.

If, during learning mode the LED does not flash to confirm, this means that the 

receiver module’s memory is FULL and no further remote control remote controls 
may be paired with it unless one of the existing remote controls is first unpaired 
(see below). 

Un-pairing
Removing single Device:
On the receiver module press the ‘Learn’ button once, red LED with flash. It is 
now in learning mode.
Using a remote control press the ‘OFF’ button intended to be unpaired; the load/
light will flash twice to confirm that the remote control is now unpaired.

Clearing Memory (will remove all paired remote controls):
On the receiver module press the ‘Learn’ button for 6 seconds (LED on receiver 
will flash), release then press once again. The load/light will flash twice to confirm 
that all remote control is now unpaired.

Operation
ON/OFF Function:
Press the ‘ON’ button on remote control, the lights will illuminate.
Red LED on receiver module will light ON for 1 second to indicate a signal is 
received from a remote control transmitter.

Press the ‘OFF’ button on remote control, the light will turn OFF.
Red LED on receiver module will light ON for 1 second to indicate a signal is 
received from a remote control transmitter.

During standby mode the Red LED on receiver module will not illuminate.

Caution:
Please leave minimum of 1.5 meters in-between 2 or more receivers. 

5

Reviews: