Cut away only
the covering
both side
Remove the horizontal stabilizer from the fuselage.
Using the sharp hobby knife, carefully cut away the
covering inside the lines which were marked above.
When you are satisfied with the alignment,
use a pencil to trace around the top and
bottom of the stabilizer where it meets the
fuselage.
5A
5B
* WARNING: When removing any covering from the airframe,
please ensure that you secure the cut edge with CA or similar
cement. This will ensure the covering remain tight.
5
85mm
4mm
85mm
4mm
HORIZONTAL STABILIZER
Cut two slots (3x7mm and 3mm deep)
along the trailing edge of the horizontal
stabilizer.
3
Full the elevator out of the
horizontal stabilizer.
Cut away only
the film both side
4A
4B
4
TOP VIEW /
Draufsicht
TOP VIEW /
Draufsicht
