Silicone tube
.46 - .50 cu.in.(x2)
7.45cc (x2)
.60 - .70 cu.in (x2)
10cc - 11.5cc (x2)
SILICON
EPOXY A
EPOXY B
CA
GLUE
Silicon Glue
Epoxy ( 5min-Typ)
Cyanoacrylate Glue
Needle nose Pliers
Awl
Scissors
Wire Cutters
Hex Wrench
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
Sander
Hobby knife
Phillip screw driver
REQUIRED ITEMS
Minimum 6 channel radio
for airplane / 7 standard
servos / 4 mini servos
1.5mm
A B
!
CA
L/R
Assemble left and right
sides the same way.
X
Drill holes using the stated
size of drill
(in this case 1.5 mm Ø)
Use epoxy glue
Take particular care here
Hatched-in areas:
remove covering
film carefully
Not included.
These parts must be
purchased separately
Check during assembly that these
parts move freely, without binding
Apply cyano glue
If exposed to direct sunlight and / or heat, wrinkles can appear. Storing the model in
a coll place will let the wrinkles disappear. Otherwise, remove wrinkles in covering
film with a hairdryer, starting with low temperature. You can fix the corners by using
a hot iron.
Read through the manual before you begin, so you will have an overall idea of what to do.
CONVERSION TABLE
1.0mm = 3/64”
1.5mm = 1/16”
2.0mm = 5/64”
2.5mm = 3/32”
3.0mm = 1/8”
4.0mm = 5/32”
5.0mm = 13/64”
6.0mm = 15/64”
10mm = 13/32”
12mm = 15/32”
15mm = 19/32”
20mm = 51/64”
25mm = 1”
30mm = 1-3/16”
45mm = 1-51/64”
Electric Set up 1:
2X Dualsky XM5050EA-7 610Kv motors.
2X Dualsky XC8018BA 80A ESC, 100A burst
2X Dualsky XP45004EX 4S, 35C, 4500mAh Lipo
2X Prop: 14x9 x3-blade Master Airscrew
Approx Weight: 1600grams / 3.6lbs
Electric Setup 2:
2X Dualsky XM5060EA-6 470Kv motors.
2X Castle Creations Edge 100AMP ESC
2X Dualsky XP45005EX 5S, 35C, 4500mAh Lipo
2X Prop: 16x10 x3-blade Master Airscrew
Approx Weight: 2200grams / 4.8 lbs
Aileron x2
Elevator x2
Rudder x2
Nose gear x1
Flap x4
Throttle x2 (Glow engine)
Extension cord for aileron servos: 70cm(x2)
Extension cord for center flap servo: 30cm(x2)
Extension cord for retract servos: 50cm(x3)
Extension cord for Rx battery pack: 30cm(x1)
Extension cord for Elevator servos: 50cm(x2)
Extension cord for outer flap servo: 50cm(x2)
Extension cord for Rudder servo: 50cm(x2)
Extension cord for Throttle servo (glow engine): 50cm(x2)
