Nexa NP-1060, User Manual, Page: 21 / 39

10.4 Jumpers Setup
The illustration shows how jumpers are setup. When
the jumper cap is placed on pins, the jumper is
“Short”. If no jumper cap is placed on pins, the
jumper is “Open”. The illustration shows a 3-pin
jumper whose pin1 and pin2 are “Short” when
jumper cap is placed on these 2 pins.
Clear CMOS JumpersCLRMOS1:
(CLRCMOS1, CLRCMOS2) 1-2: Normal
(see p.8, No. 23)2-3: Clear CMOS
Note: CLRCMOS1 allows you to clear the data in CMOS. To clear and reset the system
parameters to default setup, please turn off the computer and unplug the power cord from the
power supply. After waiting for 15 seconds, use a jumper cap to short pin2 and pin3 on
CLRCMOS1 for 5 seconds. However, please do not clear the CMOS right after you update the
BIOS. If you need to clear the CMOS when you just finish updating the BIOS, you must boot
up the system first, and then shut it down before you do the clear-CMOS action.
Please be noted that the password, date, time, user default profile and MAC address will be
cleared only if the CMOS battery is removed.
COM Port PWR Setting Jumpers 1-2: +12V
(6-pin PWR_COM1 (For COM Port1)) 3-4: RI#
(6-pin PWR_COM2 (For COM Port2)) 5-6: +5V
(6-pin PWR_COM3 (For COM Port3))
(see p.8 No. 2)
(6-pin PWR_COM4 (For COM Port4))
(see p.8 No. 22)
Backlight Power Select Use this to set up the backlight (LCD_BLT_VCC)power of
the LVDS connector.
(3-pin BKT_PWR1)1-2: LCD_BLT_VCC: +5V
Default Clear CMOS
CLRMOS2:
1-2: +BATT
2-3:
+3VSB_A