434 / 315 MHz 8 Channel Secure Remote Control
NEX Robotics Pvt. Ltd.
2
www.nex-robotics.com
Note:
•
You have to solder pad to select track antenna or a wire antenna before use as
described in the product manual before using remote control.
•
For perfect remote control operation make sure that two 0.1uF capacitors are
connected to the motor terminals with respect to motor body and robot chassis and
motor body is grounded.
•
Make sure that robot has adequate power available (at least twice of the stall
current of all the motors combined) to avoid interference caused due to power
surges in the supply.
Specifications:
Transmitter and Reciver module:
434 MHz ASK Transceiver Module
Transmitter:
•
Frequency: 434 / 315MHz
•
Power: 7V to 12V DC, 9V battery can also be used.
•
Number of control inputs: 8 (arranged in 4+4 user friendly configuration for left
and right hand)
•
Antenna: User selectable PCB track antenna or quarter wavelength wire antenna
•
Encoder: HT640 (8 command output and 10 bit security address)
•
Reverse polarity protection
•
Onboard low drop voltage regulator
•
Power switch and Power indicator LED
•
Size: 12.5cm x 5cm
Receiver:
•
Frequency: 434 / 315MHz
•
Power: 7V to 12V DC, 9V battery can also be used.
•
Outputs: 8, 5V, TTL / CMOS level, Buffered with IC 74HC245
•
8 LEDs displaying status of the commands (can be disabled by removing jumper)
•
Antenna: User selectable PCB track antenna or quarter wavelength wire antenna
•
Decoder: HT648 (8 command output and 10 bit security address)
•
Valid data confirmation output for customization
•
Reverse polarity protection
•
Onboard low drop voltage regulator
•
Power switch and Power indicator LED
•
Size: 5.6cm x 4.3cm
Output data type:
•
Outputs: 8, 5V, TTL / CMOS level, Buffered with IC 74HC245
•
Output gives logic 1 till key of the transmitter is pressed
•
You can transmit multiple commands at the same time by simultaneously pressing
multiple keys. Which also means you can use few keys as shift key and probably
control up to 255 devices.
•
Outputs are non latched types. I.E. outputs will remain logic 1 till the remote
transmitter’s key is pressed.
