Fitting your Pump
7
NEWTEAM SHOWER PUMPS
Varispeed 50 & Singlespeed
Flexible connectors should not be bent more than
90°. Where possible keep all flexible connectors
vertical.
1. Connect the flexible connectors (1) supplied to the
inlet and outlet ports of the pump. Ensure that the
adaptors fitted to the inlets have filters in position.
NOTE: These are designed to effect a leakproof
seal with the minimum of tightening. Hand tight is
sufficient, the long flexible connectors should be
on the inlets.
Ensure not to kink the flexible
hoses.
• Either inlet end can be used for hot or cold.
IMPORTANT: The hoses supplied with the
Varispeed 50 and Singlespeed should only be
connected with compression fittings. Under no
circumstances should solder fittings be used.
2. Connect the cable connected to the pump to the
electric supply, please refer to the electric section,
page 4.
3. Either by hand or using a coin, rotate boost control (2) fully anti-clockwise,
to maximum mark.
WARNING: Do not fit fuse or switch on mains electrical supply at this point.
Fig. 7. Diagram of Varispeed 50
1
2
3
4
Fig. 8. Diagram of Singlespeed
