U.S.A. HEADQUARTERS
P.O. Box 1306, Newport Beach, CA 92663
Phone: 714-751-0488 Fax: 714-957-1621
E-Mail: [email protected]
EURO WAREHOUSE
Phone:+31-35-603-2494 Fax:+31-35-603-2149
E-Mail: [email protected]
www.newmarpower.com
11
installed. This is because it might be falsely assumed that after the AC main has been shut
off the panel is no longer "hot", when it may still be, due to the automatic functioning of the
inverter. A set of AC distribution panel warning labels has been provided in the installation
kit. Choose the preferred black or white background label and affix it in a clearly visible
location at the panel.
CAUTION:
The AC outlets and AC hardwire output on the inverter remain “live” when derived
from an external source, even when the inverter is shut off.
J) Remote Panel (Optional)
Remote monitoring of inverter functions, as well as inverter output activation/shut-off, may
be obtained using model ICR-1 Remote Panel, available from NEWMAR. The panel duplicates
all of the LED status indicators (discussed in section V following) which are on the front
panel and incorporates a secondary on-off switch for the inverter.
FIGURE 4: Remote Panel Installation
The panel face and mounting hole pattern have been designed for an exact fit within a du-
plex outlet box. If preferred, it may be mounted directly to a bulkhead with the two provided
black-oxide wood screws. Note the cut-out dimensions specified in Figure 4 and take special
care when making the cut-out as the tolerances between the mounting holes and rear-
mounted circuit board are quite small.
The ICR-1 is supplied with 25 feet of cable. If additional length is required, contact the
factory for an extension cable.
The inverter/charger is supplied from the factory with an in-line connector assembly which
is located in the same compartment as the AC output wires. The connector is a telephone
jack type and has a “dummy” plug attached which enables all of the inverter functions
when no remote panel is used. Remove and
save
this plug prior to attaching the remote
25' CABLE SUPPLIED
WITH REMOTE PANEL
REMOVE FACTORY INSTALLED
"DUMMY" PLUG AND INSERT
REMOTE PANEL IN-LINE PLU
G
MOUNT PANEL IN DUPLEX
OUTLET BOX OR USE TWO
PROVIDED SCREWS FOR BULK-
HEAD MOUNT
PANEL DIMENSIONS:
4 1/2" HIGH x 2 3/4" WIDE
PANEL REAR CUT-OUT AREA
(for bulkhead mount):
2 7/8" HIGH x 2 1/8" WIDE