5
REMOVAL OF DRAWER
FOR SPECIFICATIONS PLEASE GO TO NEWLINE.CO.NZ
2
3
In production there has been two means of fastening the sliding rails to end of draw.
1. Option A - a small countersunk screw is used as indicated on drawing.
2. Option B - if no screw is in place slide both plastic lugs to centre to release.
3. Lift drawer up to clear front pin location.
4. Carefully pull draw forward and out.
REINSTALL DRAWER
To reinstall drawer, make sure front and rear pins are
engaged. Then reposition lugs into draw body.
Note: if drawer stops short of closing, this is due to
the “soft close” mechanism needing reactivation.
Push the drawer shut gently until it clicks. The soft
close should now be fully active.
Height adjustment disc
under this bracket.
OPTION B
OPTION A
OPTION B
OPTION A
