Newland NLS-HR15, User Manual

Page: 220 / 300

Enter Setup
** Exit Setup 204
Set Length Range for GM
The scanner can be configured to only decode GM barcodes with lengths that fall between (inclusive) the minimum and
maximum lengths. To accomplish it, you need to set the minimum and maximum lengths.
Set the Minimum Length (Default: 1)
Set the Maximum Length (Default: 2751)
Minimum length is not allowed to be greater than maximum length. If you only want to read GM barcodes
with a specific length, set both minimum and maximum lengths to be that desired length.
Set the scanner to decode GM barcodes containing between 8 and 12 characters:
1. Scan the Enter Setup barcode.
2. Scan the Set the Minimum Length barcode.
3.
Scan the numeric barcode “8” from the “Digit Barcodes” section in Appendix.
4. Scan the Save barcode from
the “Save/Cancel Barcodes” section in Appendix.
5. Scan the Set the Maximum Length barcode.
6.
Scan the numeric barcodes “1” and “2” from the “Digit Barcodes” section in Appendix.
7. Scan the Save barcode from
the “Save/Cancel Barcodes” section in Appendix.
8. Scan the Exit Setup barcode.