Newland NLS-HR1250-70, User Manual

Page: 53 / 172

** Enter Setup
Exit Setup 44
Reread Delay sets the time period before the scanner can read the same barcode a second time. It
protects against accidental rereads of the same barcode. This parameter is programmable in 0.1s
increments from 0.1s to 25.5s. The default delay is 3.0s. If the parameter is set to 0, the delay is infinite.
Note : This parameter only applies when the Reread Same Barcode with a Delay is enabled.
Reread Delay
Reread Same Barcode with No Delay : The scanner is allowed to reread same barcode, ignoring the
reread delay.
Reread Same Barcode with a Delay : The scanner is not allowed to reread same barcode before the
reread delay expires.
To disable rereads of same barcode, enable the Reread Same Barcode with a Delay and set the delay
to 0.
** Reread Same Barcode with No Delay Reread Same Barcode with a Delay
Example: Set the reread delay to 5s
1. Scan the Enter Setup barcode.
2. Scan the Reread Delay barcode.
3. Scan the numeric barcodes
“5” and “0”. (See the
Digit Barcodes section in Appendix)
4. Scan the Save barcode. (See the Save/Cancel Barcodes section in Appendix)
5. Scan the Exit Setup barcode.