** Enter Setup
47
Exit Setup
Continuous Mode
Continuous Mode
: A trigger press activates the scanner to scan and decode at user-specified intervals,
i.e. the timeout between decodes. Each decode session lasts until barcode is decoded or the decode
session timeout expires. To suspend/resume the operation, simply press the trigger. By default, the
scanner rereads same barcode with no delay.
Continuous Mode
Decode Session Timeout
: This parameter sets the maximum time decode session continues during a
scan attempt. It is programmable in 1s increments from 1s to 255s. The default timeout is 15s. If the
parameter is set to 0, the decode session timeout is infinite.
Decode Session Timeout
Example: Set the decode session timeout to 5s
1. Scan the
Enter Setup
barcode.
2. Scan the
Decode Session Timeout
barcode.
3. Scan the numeric barcode
“5”. (See the
Digit Barcodes
section in Appendix)
4. Scan the
Save
barcode. (See the
Save/Cancel Barcodes
section in Appendix)
5. Scan the
Exit Setup
barcode.
Summary of Contents for NLS-HR1050-7 Series
