nlscan.com
Page 145
Message Interception & Pack
Message Interception & Pack
Code Programming ON
Code Programming OFF
Tools
General Programming
For example, intercept QR Code from 1st digit to 20th ascending and from 113th digit to
140th ascending.
1.
Read
“
Code Programming ON
”
2.
Read
“
Enable Interception
”
3.
Read
“
Program Intercept Option
”
4.
Check Symbols ID Number table for QR Code
5.
Read below digit barcodes
Programming 2D Intercept Option
Rules
：
Maximum intercept 3 barcode message sections
1
、
Maximum value is 9999 for start digital and end digital
2
、
Overlaps of barcode message sections are allowed and work independently.
3
、
Start unit and end unit determine its message section. In the above example, ascending
4
、
“
000001
”
and
“
000020
”
means the
fi
rst 20 digits.
To intercept only one digit, program start unit and end unit to be the same value.
5
、
When programming 2D intercept option, read digit codes as interception
command. The rules is as below
：
The interception command has two parts, which are barcode type
»
part(Symbol ID) and data interception part. A command could have several data
interception parts.
A barcode type part(
»
Symbol ID) uses a unit, such as
“
005
”
; a
data interception part uses three units, including intercepting direction
unit:000(Ascending) or 001(Descending), start unit and stop unit.
Barcode type part and intercepting direction regards a 3-digit decimal
»
number as a unit; but start and stop digit regards a 6-digit decimal number as
a unit. They uses 6 digits to present 4-digit value. The
fi
rst two digits are for
thousandth and next two digits for hundredth. For example, 001013 means 113.
There is only one type of barcode to be setted to intercept in a time.
»
digit
033
000
000001
000020
000
001013
001040
Denote
symbol ID
ascending
The 1st digit The 20th digit
ascending The 113th digit The 140th digit
Barcode Type
Data Interception 1
Data Interception 2
