** Enter Setup
17
Exit Setup
Use of Programming Barcodes
Scanning the
Enter Setup
barcode can enable the scanner to enter the setup mode. Then you can scan
a number of programming barcodes to configure your scanner.
The HR11 Plus is in the setup mode by default. In real application, programming barcodes hardly overlap
with non-programming barcodes, so it is unnecessary to exit the setup mode each time you finish the
configuration.
Some functions or options may involve parameter value settings that require scanning numeric barcodes.
To find the numeric barcodes, see the “Digit Barcodes” section in Appendix.
The scanner can be configured to send or not to send programming barcode data (i.e. programming
command) to the host device by scanning the appropriate barcode below. By default, the
Do Not
Send
the Programming Barcode Data
option is enabled. Note that restarting/rebooting the scanner will reset
this parameter to its default value.
** Do Not Send the Programming Barcode Data
Send the Programming Barcode Data
Factory Defaults
Scanning the following barcode can restore the scanner to the factory defaults. See the “Factory Defaults
Table” in Appendix for more information.
Note: Use this feature with discretion.
Restore All Factory Defaults
Summary of Contents for HR11+ Aringa
