LAYOUT NET ON TABLE
Layout the net on the table as shown. This will
position the net for easy installation on the frame.
Be sure the fabric frame pockets are on top.
9
ATTACH FRONT SUPPORT TO TABLE
Spread the legs of the Front Support Mechanism
apart as wide as possible. Then attach the
mechanism by angling it downward and pushing
it onto the end of the table (A). When positioned correctly
the rubber pad rests on top of the table, the two legs
contact the bottom of the table, and the center rib of the
Support Plate aligns with the centerline of the table (B).
5
ATTACH FRAME TO FRONT SUPPORT
Place the Pivot Pin next to the Front Support
Mechanism. With one hand, pick up the frame by
the Frame Bracket and position the bracket
against the back of the Front Support Mechanism. With
the other hand, insert the Pivot Pin through both holes of
the Frame Bracket and the hole of the Front Support.
Secure in place with an E-Clip (use pliers if needed).
RAISE REAR FRAME MEMBERS
Place hands as shown
and lift slightly with
right hand. Depress
the pop button and rotate the
Rear Frame into its upright
position. Repeat on the left
side.
INSERT ADJUSTMENT SCREW
Screw the Adjustment
Screw with wing-
shaped head into the
screw hole at the center of the
Frame Bracket. Tighten it only
to the point where it begins to
move the frame.
7
A
B
A
B
6
8
THREAD NET ONTO FRAME
Pick up the
net by the
open
end of
one of the frame pockets
and slip the net over the
frame. Continue threading
the net
until about half
of
the Rear Frame is covered.
Repeat on the other side. After both sides are threaded
half way, continue threading the net until the
closed
end of
the frame pocket prevents further threading.
10
➨
➨
➨
INSTALL WIRE CLIPS
Insert a Wire Clip at the end of the Rear
Frame. Capture the black adjustment string
in the clip before passing the clip through a
buttonhole in the frame pocket and pressing it into a hole
in the frame (A). Insert another clip at the
back upper corner
of the frame. This clip also passes through a buttonhole
but does not capture a string (B). Install another clip at the
frame’s
front lower
corner (C). This clip does NOT pass
through the frame pocket or capture a string (at least, not
yet). Repeat on the other side.
11
A
B
C
ADJUST FRONT STRINGS
Locate the black and
the white strings at
a front corner of the
net. Pass the string ends through
the wire clip you installed in Step
11C. Open a
Square
Cordlock by
pressing on its top and insert the 2
strings through the cordlock. Push
the cordlock up the string until it
stops at the Wire Clip. Repeat on the other side, but pull
both strings tight so the front edges of the net are taut and
straight.
CAUTION:
Overtightening the strings can bend
the frame inward. The strings should be taut, but not so
much that they bend the frame.
12
INSTALL REAR ADJUSTMENT STRING
Take the Rear Adjustment String and insert
one end through the Wire Clip at a
upper
rear
corner (11B). Then pass that end
through the nearest hole of the net and into the
interior
of
the net (A). Pull the string to the
opposite upper rear corner
and pass it through the net hole closest to the Wire Clip at
that corner. Pull it through that clip and secure that end
with a
Round
Cordlock (B). Go to the opposite corner and
secure the other end of the string with the other Round
Cordlock and tighten the string. Again, the string should
be taut, but be careful NOT to overtighten. Your net
should look like C. (Photos at top of next column.)
13
Pop
Button
E-Clip
Pivot
Pin
Square
Cordlock
Wire
Clip
Open Ends
Closed Ends
