z
Place the heater on a firm, level surface free from obstructions and at least 3 feet
away from walls or other objects such as furniture, curtains, plants, or combustible
materials.
z
To program your electric oil-filled heater, refer to the control panel diagram in Fig. 2
below:
z
Press the “POWER” button to turn the heater ON.
z
Select the heat level you desire by pressing the POWER button. T
he heater will turn on
in the following sequence: HI-MED-LO
. On LO, the heater will operate at 600W. On
MED, the heater will operate at 900W. On HI, the heater will operate at 1500W.
z
There are 5 temperature settings, ranging from MIN to MAX. Press the “TEMP” button
to select the desired temperature. T
he heater will operate in the following sequence: 65
o
F
, 70
o
F
, 75
o
F
, 80
o
F, and
85
o
F
.
z
Press the “TIMER” button to set the desired heating time. There are three choices: 2H
(2 hours), 4H (4 hours), and 8H (8 hours).
z
Timer setting: This heater has an 8 hour On/Off timer. You can set the “On” timer when
the heater is in “stand-by” mode (unit is plugged in but not operating), or you can set the
“Off” timer when the heater is operating. For example, you can plug in the heater and set
the timer to turn the unit on after 2 hours, or you can also set the timer to turn the heater
off after 4 hours when the heater is in operation.
UNPACKING AND SET-UP INSTRUCTIONS
Carefully unpack your heater and remove the wheel assemblies from the packaging. Refer
to Fig. 1 below:
1.
Make sure the heater is unplugged and
turned off.
2.
TURN THE HEATER UPSIDE DOWN.
3.
Position the wheel base assemblies
between the end fins as shown.
4.
Insert each U-shape screw into the holes
of each wheel holding plate.
5.
Insert the butterfly nuts and screw them
in tightly.
6.
Turn the heater upright.
7.
Your heater is now ready for use.
CAUTION: To prevent a possible fire, do not operate the heater without the wheel
assemblies attached. Only operate the heater in an upright position with the wheels on the
bottom and controls on top. Operating the unit in any other position could result in fire,
personal injury, and/or property damage.
OPERATING INSTRUCTIONS
Fig. 2 - Control Panel View
IMPORTANT!
Your heater is equipped with a
polarized alternating current
line plug (a plug with one blade
wider than the other). This plug
will fit into the power outlet only
one way. This is a safety
feature. If you are unable to
insert the plug fully into the
outlet, try reversing the plug. If
the plug still does not fit,
contact your electrician to
replace your outlet. DO NOT
defeat the safety purpose of
the polarized plug by forcing it
into a non-polarized outlet, or
by modifying the prongs down
to fit.
Fig. 1 - Upside down view
Wheel
holding
plate
U-shaped
screw
