1. Insert the two #8-32 bolts into the
slots on the back of the power bar.
Secure the screws in the lower gap
towards the cord.
Using the supplied 9/32” wrench,
fix the power bar in place with the
provided lock washers and #8-32
nuts.
note:
It may be necessary to grip the
ends of the bolt with a pair of pliers to
prevent the bolt from spinning while
tightening.
Install the power bar onto the
workbench by inserting the two
screws through the corresponding
holes on the front, or sides of the
workbench.
If installing the power bar on the
front of the workbench you can feed
the cord for the power bar through
the rubber grommets on the front
and back of the workbench.
inStall taBlet Stand (optional):
1. Angle the tablet stand and insert
through slots located on the workbench
tray and allow the hooks to engage under
the workbench tray.
Use the tablet stand with your favorite
device.
Mounting
Power Bar
2.
3.
note:
Ensure your device is stable inside the stand. Newage products will not be
responsible for any damage caused to your device as a result accidental droppage or use
of this stand.
1
2
3
Thank you
for purchasing fromNewAge Product.
