2
I N S T A L L I N G T H E E X P A N D E R
Each LFO Phase Expander comes with a 4 pin connector
suitable for connecting it with the Quad LFO. This should
be plugged such that the red wire is aligned with the "RED"
text on each PCB. The Quad LFO has four connectors, one
for each LFO. You can plug an expander into any one or
more of them. Note that both the Quad LFO and the Ex-
pander must be connected to power.
S E L E C T I N G P U L S E O R S I N E O U T P U T W A V E F O R M S
Sine wave output
Pulse wave output
On the reverse of the Quad LFO module there's a jumper to set each output to either sine or pulse
(square) waveforms. To switch, gently take hold of the blue jumper and pull it off the header. Then
place it in the new position and press it until it is flush with the black plastic of the pin header.
