New lift FST-2XTs, Manual

Page: 23 / 50

Replacing FST-2s with FST-2XTs
Functiontests
ManualforreplacingFST-2swithFST-2XTs 23
5.4 Function tests
► Switch on the MAIN SWITCH (Q1) and the fuse (F4).
► Wait until the FST-2XTs software has completely started.
► Switch on the circuit breaker for car and shaft light and, if applicable, the UPS.
► Activate the emergency call control system or the emergency horn.
► Switch on the AUXILIARY MODE CONTROL (AUX).
Check the lift ID-number
► Simultaneously press buttons

+

and check the lift ID number.
If the lift ID number is displayed correctly:
»
No further steps necessary.
If the lift ID number is not displayed correctly:
»
Perform data transfer again.
If the lift ID number is not displayed correctly after repeating data transfer:
»
Upload the necessary ID data using the FST editor program or
»
Perform complete commissioning according to the commissioning manual
See MIA FST-2XT/XTs.
Position check
► Use buttons

+
�
on the display to set position value P = XXXXX.
► Turn the AUXILIARY MODE switch to UP and observe the set value.
The position value must increase.
► In the same way, turn the AUXILIARY MODE switch to DOWN and observe the set value.
The position value must decrease.
If the position values correspond to the selected direction of movement:
»
No further steps necessary.
If the position values do not correspond to the selected direction of car movement:
»
Press button

to change to the
main menu
.
» Use buttons
�
/
�
to navigate to the
Positioning/Global/Direction
submenu and confirm each with

.
»
By confirming selection
Left/Right
, you can change the direction of rotation.
» Repeat the position check.