New Leader NL345/MULTAPPLIER, Operator'S Manual

Page: 67 / 142

- 67 -
NL345
www.NewLeader.com
(800) 363-1771
312884-AA-C
Clean Up
NOTICE!
High pressure wash can inject water and/or fertilizer into control components, causing damage�
Use caution when cleaning these areas�
Thoroughly wash unit every two to three days during the operating season to maintain minimal maintenance
operation� Hose unit down under pressure to free all sticky and frozen material�
It is important the unit be thoroughly cleaned at the end of each operating season� All lubrication and
maintenance instructions should be closely followed� Repaint worn spots to prevent formation of rust�
Lubrication & Maintenance
Tighten nuts to 50 ft-lb (67�8 N-m) following a
crisscross sequence as shown in Figure 9�
After the wheel is installed inspect the seating of
the wheels on all four pilots and turn the wheel
checking for irregularity of the wheel assembly� This
will ensure the wheel is seated on the pilots and flat
against the drum�
Tighten all nuts to 450-500 ft-lb (610�2-678 N-m)
using the crisscross sequence as shown in Figure 32�
Repeat torque sequence until all nuts are consistent
to 450-500 ft-lb (610�2-678 N-m)�
Figure 9
End-of-Season Storage
WARNING
Never store implement with material in bin� Implement could tip and crush or strike
someone causing serious injury or even death�
1� Refer to “Pre- & Post-Season Checklists” at the end
of this section� Complete End-of-Season Checklist as
required�
2� Store implement indoors on a hard, level surface, with
wheels blocked to prevent rolling�
3� Lower jack to support the implement so that it is
level� Ensure that the jack is placed securely on a hard
surface�
4� Place all power connections in storage positions as
shown in Figure 10:
• If implement is equipped with M
ULT
A
PPLIER
, store
auxiliary hose in provision on hose guide (A)�
• Place PTO shaft in storage position and secure
with pin (B)�
• Store light connector in storage bracket located on
hose guide (C)�
A
C
B
D
A
C
B
D
Figure 10
• Plug ISOBUS connector into storage provision to prevent entry of dirt and debris (D)�
5� Disconnect implement from tractor�