- 59 -
NL4258/4330G4 EDGE
www.NewLeader.com
(800) 363-1771
312521-AA-C
Lubrication & Maintenance
Figure 4 - Spinner Fin
Figure 5 - Spinner Deflector
Figure 6 - Material Divider
Spinner Fins
Visually inspect spinner fins (Figure 4) daily for
build-up of material and wear� Spinner discs
and fins must be kept clean and polished.
Even a small build-up of material on a spinner
can significantly affect the spread pattern.
Rough, bent or worn fins will produce bad
spread patterns. Replace worn fins or discs as
needed� See Fin Kit Installation Instructions for
replacement part numbers and instructions�
Spinner Deflectors
Visually inspect spinner deflectors (Figure 5)
daily for build-up of material and damage�
Clean as needed� Even a small build-up of
material on a spinner deflector can affect the
spread pattern� If damaged, bent or otherwise,
replace� See Parts List in this manual for
replacement part numbers�
Material & Hillside Flow Dividers
Visually inspect material divider (Figure 6) and
hillside flow dividers (as equipped) daily for
build-up of material and wear� Any build-up
of material on divider components can affect
performance� Clean as needed� Replace worn
or damaged parts as necessary� See Parts List
in this manual for replacement part numbers�
