New Holland EH35, Service Manual

Page: 28 / 41

02
-1-11
A:16 …
A:15…
B: 23 mm
B:23 …
B:19 …
A: 50 mm
A:
5100 m
m
B:
4700 m
m
(C)
(D)
LIFTING ANGLE
CABLE fl14
A : 4800 mm x 2 Q’TY
B : 4400 mm x 2 Q’TY
CABLE fl14
A : 2600 mm x 1 Q’TY
B : 2200 mm x 1 Q’TY
A:17 …
A:18 …
B: 23 mm
B:23 …
B:19 …
A: 50 mm
A, B
: 4700 mm
(C)
(D)
LIFTING ANGLE
CABLE fl14
A, B : 4400 mm x 2 Q ’ TY
CABLE fl14
A : 2300 mm x 1 Q ’ TY
B : 2200 mm x 1 Q ’ TY
8. MACHINE LIFTING PROCEDURE
Carry out the lifting work at a level ground.
[1] Manipulate each operating lever to take the ma-
chine a position as shown in the figure.
[2] Operate the boom swing pedal [EU • OCEANIA]
or slew/swing lever [USA] to face the boom di-
rect front.
[3] Stop the engine, and make the safety lock le-
ver to “LOCKED” position. Then take off the ma-
chine after ensuring for no abnormalities around
the operators seat.
[4] Install shackles to both bores (C) provided at
both ends of the dozer blade, and put the wire
ropes on them.
[5] Put the wire ropes on the (D) portion of the
boom.
[6] If any portions of the wire ropes directly get
touch with the machine when the wire ropes
are put up, protect the machine from damages
by means of applying a wooden piece or rag
between them.
[7] Slightly lift the machine to ensure the balance,
then lift up the machine.
Note : This figure is calculated with Japanese stan-
dard bucket.
Bucket weight
SK30SR-2 : 88kg (194 lb)
SK35SR-2 : 91kg (201 lb)
MODEL
A : SK30SR-2 3,000 (6,620) 3,060 (6,750)
B : SK35SR-2 3,510 (7,740) 3,570 (7,870)
WEIGHT kg(lb)
EU • OCEANIA USA
MODEL
A : SK30SR-2 3,110 (6,860) 3,130 (6,900)
B : SK35SR-2 3,620 (7,980) 3,640 (8,030)
WEIGHT kg(lb)
EU • OCEANIA USA
• The wire ropes to be used for lifting the machine
should have sufficient strength against the ma-
chine weight.
• Improper lifting method and/or roping manner
might cause for a movement or slip of the ma-
chine while it is lifted up, resulting serious injury
or damages on the machine.
• Do not impose a load suddenly on the wire ropes
and slings.
• When the lifting work is carried out in cooperation
with plural persons, make sure to ensure every
situations with exchanging signals with each other.
• During the lifting work, keep any persons away
from around the lifting machine, especially under
the machine
LIFTING PROCEDURES FOR THE MACHINE
COMPLETE