New Holland E26C, Operator'S Manual

Page: 160 / 282

6 - MAINTENANCE
Break-in period
Grease points (Bucket)
Lubricate the bucket linkage (arm-bucket connection
and arm-bucket link connection) and the bucket cylin-
der pin (rod side) every
10 h within the first 50 h , then
lubricate every 50 h .
Lubricate the bucket cylinder pin (head side) every 10 h
within the first 100 h , then lubricate every 250 h .
To lubricate the bucket linkage and the bucket cylinder
pin (rod side) refer to page
6-26 .
To lubricate the bucket cylinder pin (head side) refer to
page
6-41 .
Grease points (Boom and arm)
Grease the boom, the arm, and the boom swing post
every
10 h within the first 100 h , then grease every
250 h .
To grease the boom, the arm, and the boom swing post
refer to page
6-41 .
Grease points (Blade)
Grease the blade every 10 h within the first 50 h , then
grease every 50 h .
To grease the blade refer to page 6-27 .
Tightening torques
Check the tightening torques after the first 50 h of ser-
vice, then check the tightening torques every 250 h .
To check the tightening torques, see page 6-40 .
Fuel filter
Replace the fuel filter after the first 250 h of service,
then replace the fuel filter every 400 h .
To replace the fuel filter perform the operations de-
scribed on page
6-42 .
Hydraulic oil return filter
Replace the hydraulic oil return filter after the first 250 h
of service, then replace the hydraulic oil return filter ev-
ery
1000 h .
To replace the hydraulic oil return filter perform the op-
erations described on page
6-49 .
NOTE: replace the hydraulic oil return filter every 200 h of
service if hydraulic breaker is used continuously.
6-18