Shaver
1:50
3D-08
Installation Instructions
For All Cabinetry
FIRST THINGS FIRST!
BEFORE proceeding with installation, please check goods carefully. If
goods are incorrect, faulty or damaged, DO NOT proceed with installation and contact New
England Joinery immediately. No claims for damages/defects will be accepted after installation.
1.
Ensure Your Wall Is Flat & Plumb
Before starting, check that your wall is plumb and flat. If not, the
cabinet will need to be packed out so that it is sitting level, otherwise
the cabinet will twist, causing the doors and drawers to be out of
alignment and not function correctly.
It is recommended that you do NOT tile in your cabinets –
tiles should extend behind the cabinet and clearance allowed for
doors and drawers to open (filler panel required where cabinet is going
hard against a wall).
It is recommended that vanities are installed over 300mm from any
wet area such as baths, spas and showers.
Ensure wall is plumb
Ensure wall is flat (no gaps
between wall and level)
2.
Fix Your Cabinet / Mirror, Making Sure It Is Level & Plumb
Vanities: Fix as noted above
Vanities: Check cabinet is
level and plumb
Shaving Cabinets: Fix with suitable
screws in each corner and check that
cabinet is level and plumb
Fix your cabinet using screws through the solid back of the cabinet.
The screws should be suited to the stud material and have a pan or
counter sunk head. Provide a horizontal row of screws within 100mm
vertically from the top of the cabinet at a maximum of 300mm
horizontal spacing. The screws closest to the left and right edge of the
cabinet should be within 100mm of each side.
For vanities, ensure that the cabinet is level and plumb in all directions,
using a spirit level. If not, remove the cabinet and pack or straighten
the wall accordingly. DO NOT install the top until you are sure that the
cabinet is plumb and level in all directions.
