- 17 -
6-2. Unit Installation Procedure
1. Determine where to place the base unit (positioning). Secure the mounting plate to the wall
with the two mounting screws (M4x8).
2. Anchor the base unit to the mounting plate by inserting the mounting plate into the slot on
bottom of the base unit, and secure using the mounting screw (M4x8).
3. To install the sensor unit at this time, refer to 9-2.
“Sensor Unit
Installation/Replacement
”.
To install the sensor unit at later stage, move to step 4.
4. Ensure that the main unit power switch is in the OFF position.
5. To install the main unit, pull forward and hold both latches of the
base unit. Connect the main unit by sliding it onto the rails of the
base unit.
6.
Push the
base unit’s latches back into place so that the white
lines are visible, indicating the latches have been locked
.
Ensure that the latches are in the fully locked position (white lines visible). Normal
detection is not possible if the latches are not fully locked.
Pitch
Mounting screw
Rail
Pull latches forward.
Fully push latch (lock position).
White line
Latch
Mounting screws
Mounting plate
