NCS-3230 Rev C Instruction Manual
Copyright © 2003, 2004 New Communications Solutions, LLC
5
2.5 RECORD SELECT Switches and LEDs
These switches select which radio(s) will be recorded. When a switch is
engaged (the “in” position), the corresponding yellow LED will light
indicating which radio will be recorded. Any or all radios can be recorded
simultaneously since the receive audio is mixed together inside the Multi-
Rx
TM
.
2.6 RECORD Controls
The RECORD controls consist of two pushbutton switches and one red
LED. The ENABLE switch enables the recording function when pushed
in. When in the “out” position, no recording can occur regardless of the
settings of other controls.
With the RECORD function enabled, the MAN/VOX switch controls
whether recording will be signal activated (VOX) or always on (Man).
VOX operation depends on having enough audio level. The BUSY lights
indicate the signal level and if they are on, there is enough audio to
activate the VOX record function. There is a delay (5-10 sec) built in to
the drop out time of the VOX record function so the recorder will continue
to record during short pauses in the received audio.
When the record function is on and recording, the RECORD ON LED will
light.
2.7 SPEAKERS Switch
This switch turns the speakers on or off. The headphone output is always
active.
2.8 PHONES Jack
This jack is for use with a stereo headphone. Both channels of audio, Left
and Right, are present at all times unless one of the Mute functions is
activated.
2.9 BALANCE and VOLUME controls
These controls operate the same as on a consumer stereo system.
2.10 MODE
Switch
This switch selects either the
Normal
or
Spatial
modes of operation. The
“in” position (S) selects
Spatial
mode; the “out” position (N) selects
Normal
mode. See Section 4.2 for a description of the two modes.