STEP 17.
Install 13/16” chrome plug in temperature
gauge hole in smoke chamber lid if you have not
purchased the optional Model 3000 temperature gauge
(12503000).(To order call 1-800-232-3398).
STEP 18.
Install the grease can wire clip. From below
the unit push the wire clip up through the large hole and
then pull down so that the tip of the wire clip goes down
through the smaller hole.
A 12 oz. tin can (i.e. soup can or vegetable can) will fit
nicely into clip to collect grease.
STEP 19.
Install die cast logo plate by inserting the pins
on logo plate through the two holes in the lower right
corner of smoke chamber door. Secure in place by
slipping the Tennerman clips over the protruding pins
and pushing them until they are snug against the inside
surface of door.
STEP 20.
If you wish to grill in the smoke chamber,
insert BOTH wire fire grates into the smoke chamber
and place them on the bottom of the cooking chamber
to build your fire on. Insert the two porcelain cooking
grills into the smoke chamber and rest them on the
protruding grill support bolts.
Firebox cooking grill
If you wish to use the firebox to grill with, you will need to install 4 10-24 x 1” Combo truss
head screws and 4 #10-24 flange nuts into the 4 holes provided in the firebox. Use the smallest of the three
cooking grates in the firebox.
Firebox fire grate installation for smoking:
Insert a
wire fire grate into the firebox through the barn door
opening and rest it on the bottom of the firebox
chamber. When smoking food, do not put a cooking
grate in the firebox.
Firebox cooking grill installation
Insert porcelain cooking grill into fire box as shown.
STEP 21.
Diamond Fire
TM
plate (24810036) installation
(FOR UNITS WITHOUT DIAMOND FIRE ACCESSORY
(22504850)).
Locate the 2 3/32” x 2 11/16” cover plate in the hardware
box. At the bottom right end of the firebox are the holes
for the Diamond Fire Propane igniter accessory (not
included). Align the two holes in the cover plate with the
holes on each side of the large hole in the firebox.
Secure using 2 #8-32 x 1/2” combo pan head screws and
2 #8-32 keps nuts.
