New Air Refrigeration
CONTROL BOARD
INSTRUCTIONS
9
NUR Series: Control Board Instructions
XR06CX
To display target set point, in programming mode it selects a parameter
or confirms an operation.
To start a manual defrost
.
In programming mode it browses the parameter codes or increases the displayed value.
In programming mode it browses the parameter codes or decreases the displayed value.
1. Enter the Programming mode by pressing the keys for 3s (the “°C” or “°F” LED starts blinking).
2. Released the keys, then push again the keys for more than 7s. The L2 label will be displayed
immediately followed from the HY parameter.
NOW YOU ARE IN THE HIDDEN MENU.
3. Select the required parameter.
4. Press the key to display its value
5. Use to change its value.
6. Press to store the new value and move to the following parameter.
To exit: Press or wait 15s without pressing a key.
NOTE1: if no parameter is present in L1, after 3s the “nP” message is displayed. Keep the keys
pushed till the L2 message is displayed.
NOTE2: the set value is stored even when the procedure is exited by waiting the time-out to expire.
