Nevadent 368330 2101, Operating Instructions Manual

Page: 11 / 40

■ 8
│
GB│IE│NI│CY NZAE 3.7 A1
♦ Divide your mouth into four parts (quadrants): upper right, upper left, lower right and
lower left.
♦ Begin in one quadrant:
Start with the brush head
1
on your gums, and move the brush upwards/down-
wards from the gums to the crown of the tooth. Continue in this manner on both the
inside and the outside of the tooth. Start again on the gums for each individual tooth.
Do not forget the back surfaces of the rear molars. To clean the chewing surfaces,
guide the brush over the chewing surfaces with a little pressure.
♦ After 30 seconds, the toothbrush stops twice briefly to signal that you should start
cleaning the next quadrant. Clean all quadrants using the same technique.
♦ After two minutes, the toothbrush pauses briefly 4 times. This lets you know that you
have cleaned all four quadrants and complied with the dental recommendation of
two minutes of cleaning.
♦ Switch off the toothbrush and rinse the brush head
1
thoroughly under running
water.
♦ Remove the brush head
1
from the handset. To clean the drive shaft
2
and the
handset, hold them under running water for a short while. Hold the handset so that
the drive shaft
2
is pointing downwards at an angle.
Transport lock
The toothbrush is equipped with a transport lock to secure it from switching on uninten-
tionally.
♦ Press and hold the On/Off button
3
until the charging indicator lamp
4
flash-
es green 5 times. The transport lock is now activated and the charging indicator
lamp
4
flashes green 5 times if you attempt to switch on the toothbrush.
♦ Press and hold the On/Off button
3
until the charging indicator lamp
4
lights up
green. The transport lock is now deactivated and the toothbrush can be switched on
again.
IB_368330_NZAE3.7A1_GB-IE-NI-CY.indb 8 IB_368330_NZAE3.7A1_GB-IE-NI-CY.indb 8 25.06.2021 13:03:52 25.06.2021 13:03:52