Nevadent 324037 1901, Operating Instructions Manual

Page: 34 / 52

NSZB 3.7 B3
GB
│
MT
│ 31 ■
Cleaning with the floss attachment
You can use the floss attachment
e
to clean interdental spaces with the aid of
dental floss .
1) Place the floss attachment
e
on the hand element .
2) Take around 15 cm of standard commercial dental floss and wrap one
end around the fixture
w
2–3 times .
NOTE
If the dental floss slips off the fixture
w
, you can tighten the screw with a
Phillips screwdriver .
3) Pass the dental floss tightly through the guide grooves
q
on the floss at-
tachment
e
.
4) Then wrap the other end around the fixture
w
2–3 times so that the
dental floss is stretched taut and does not come undone while cleaning the
interdental spaces .
5) Guide the dental floss between two teeth with the toothbrush switched off .
6) Switch the appliance on . When cleaning with the floss attachment
e
, use
the settings “Clean” or “Soft” .
7) Clean the interdental space with careful up-and-down movements .
8) Clean all the interdental spaces as described above .
9) When you are finished, switch off the toothbrush and take it out of your
mouth .
10) Remove the dental floss from the fixture
w
and dispose of it .
11) After use, clean the floss attachment
e
thoroughly under running water .
12) Remove the floss attachment
e
from the hand element .
To clean the drive shaft
2
and the handset, hold them under running water
for a short while . Hold the handset so that the drive shaft
2
is pointing
downwards at an angle .