Neuton CE 6.2, Safety & Operating Instructions Manual

Page: 33 / 68

NEUTON CE6.2
Battery-Powered Mower
-
Safety & Operating Instructions
29
Charging with the Battery out of the Mower
1. Remove the Battery from the Mower.
2. Remove the Protective Plug from the Charger Receptacle
on the Battery and plug in the round Charger Connector
(
Figure 24 ).
3. Plug the Charger into a standard 110-Volt wall outlet.
The RED light on the Battery will illuminate indicating a
connection between the Battery and the Charger. The
LED light on the Charger will quickly change from GREEN
to RED indicating that the Battery is charging.
4. After ten (10) to twelve (12) hours, the Battery should be
completely recharged. The LED on the Battery will not
turn OFF or change colors.
NOTE: The LED on the Charger may not have changed to
GREEN and may still be RED after twelve (12) hours of
charging. This does not mean that the battery is not
completely charged. Do not charge any longer than 12
hours.
5. Remove the charger from the battery and from your
standard 110-Volt wall outlet and place both the Battery
and the Charger in a
DRY environment for storage until
you need them again.
NOTE: For the first five (5) hours, the Charger may be warm to
the touch. This is normal and does not indicate a
problem.
ALWAYS KEEP THE BATTERY IN A DRY PLACE.
Disconnecting the Charger
Remember to disconnect the Battery from the Charger using this sequence:
1. Pull the plug from the Charger out of the wall outlet.
2. Disconnect the Charger from the Battery and replace the Protective Plug.
ALWAYS DISCONNECT THE CHARGER FROM THE ELECTRICAL (WALL) OUTLET FIRST, AND THEN
DISCONNECT THE ROUND CHARGER PLUG FROM THE BATTERY. IF YOU REMOVE THE ROUND CHARGER
PLUG FIRST, THE EXPOSED CONNECTOR COULD BE ACCIDENTALLY SHORT-CIRCUITED BY FOREIGN
MATERIAL, WHICH MIGHT CAUSE A FIRE.
Figure 24
Protective Plug