Neurotech Recovery - Back, Instructions For Use Manual, Page: 13 / 53

11
ENGLISH —
S
E
TTI
N
G
U
P
C
ON
DU
C
TI
VE
G
ARME
N
T
S
5.2 Setting Up A Back Treatment
This section explains how to apply the back garment before using it for the first time. Gel pads should be applied to the garment
before putting it on.
Back Garment Placement
Step 1 : The Neurotech Recovery - Back should always be centered over the spine. Place the peak of the curved section (pointing
down) directly against your spine to align the garment and then hold the ends in both hands as shown. (Fig. E) . Ensure the
garment is spread equally on both sides of the body.
You can check the horizontal positioning by putting your finger into the die-cut circle on the back of the garment and feel for
your spine. The die-cut hole should be centered low and over your spine. (Fig. F)
Step 2 : Place your fingers inside the pockets at either end of the garment and pull the two ends around to meet in front of you.
Wrap the left-hand side around your body first. (Fig. G)
Step 3. Next, wrap the right-hand side over the left and press the two ends together so that the belt fastens comfortably. Press
the ends of the garment against your body to ensure it is securely fastened.
Step 4. Then simply press the outer layer against the inner layer to fasten. (Fig. H)
5.3 Setting Up An Abdominal Muscle Treatment
Abdomen Garment Placement
Step 1: Position the abdomen garment around your waist so that the pads are pressed firmly against your skin, positioning the
large square pad over your navel (belly button).
Step 2: Stretch the ends of the belt around your waist (Fig. I), until the small pads are between your hip bone and ribs on either
side of your body (Fig. J). Fasten the belt tightly around your waist, but no so tight as to cause discomfort. The pads are water-
based, so you may find they are cool when placed on your skin.
Recovery Back Garment IM Rev 6A_Layout 1 28/02/2013 11:04 Page 11