Container Cleaning System TANKO®EX-R64T
60/80
Translation - Operating/installation instructions 2020/03
7 Maintenance
NOTE
Risk of breakage due to material overload!
Pressure surges when switching the cleaning medium on or off, in particular pressure
surges which exceed the operating pressure, and gas components in the cleaning
medium can cause hammering in the cleaning device.
There is a risk of material damage, e.g. leakage in the pipe system or on connected devices.
Prevent pressure surges (“water hammers”) and gas components in the cleaning
medium, e.g. by:
–
Installing a water hammer arrester or pressure relief valve in the supply line,
–
Slowly starting/stopping the pump and
–
Slowly opening/closing the shut-off fitting (e.g. valve or ball cock).
7.3
Removal
The safety instructions in
Section 7.1 Safety Instructions for Maintenance
removing the device from the container.
WARNING
Risk of chemical burns and heat burns when opening the container!
The supply line is pressurized. The person could be hit by cleaning jets or come into
contact with residual fluid from the supply line and device. There may also be hot vapors
in the container.
There is a risk of death or severe physical injury.
Do NOT open the container during the cleaning process.
Before starting work, observe the work steps of the switch-off procedure (see
Section 7.2
Before opening the container, observe the cooling and draining time.
Wear personal protective equipment (e.g. protective gloves, safety shoes, safety goggles).
