Neumann.Berlin GKH 310, Mounting Instructions

Page: 6 / 8

4
| GKH 310
Attaching the GKH 310
To attach the GKH 310 to the cabinet:
X
Make sure that the felt pads are attached to the GKH 310 as shown on the previous page. If
you do not use the felt pads or if they are attached other than shown on the previous page,
you risk to scratch the surface of the KH 310.
X
Hook the GKH 310 into the upper groove of the KH 310.
• The recesses
3
of the GKH 310 are located above the treble driver and below the mid-
range driver (see figure).
• Proceed carefully, avoid scratching the GKH 310 and KH 310 and make sure not to damage
the drivers.
X
Tilt the GKH 310 downwards, pull it over the lower edge and hook it into the lower groove
of the KH 310 (see figure).
CAUTION
Material damage and/or damage to the GKH 310 due to dropping of the product!
If you attach the GKH 310 to a vertically mounted KH 310, it might slip out of the groove and
drop down. This can cause material damage and/or damage to the GKH 310.
X
Do not attach the GKH 310 to upright mounted loudspeakers.
Attaching the Neumann logo
X
Attach the Neumann logo to either the left or right
hand side
depending on your loudspea-
ker version (see figure).
35 mm
40 mm 40 mm
EN