ENGLISH TRANSLATION of the original instruction manual. The instruction
manual was translated with all due care and attention. However, we do not
accept liability for any translation errors. The German version of this
instruction manual is definitive.
Before commissioning
Please read the operating instructions carefully before using the appliance.
Check the unit for visible damage. For damage of any kind, please notify the
customer service.
The power cord and plug must not be damaged. In these cases, a qualified customer
service must be checked before commissioning.
Basic safety regulations
The product you purchased corresponds to the state of the art and the recognized
safety regulations, but can create dangers. Please operate the crepes unit only in
perfect condition and in compliance with the operating instructions. The device is to
be used only for the specific purpose.
All technical interventions, including assembly and maintenance, should be
performed by trained personnel. If these conditions are not adhered to, the warranty
obligation of the manufacturer expires. Due to constant technical improvements,
changes in the operation may occur.
General information
•
The device has been tested for functionality, but damage can occur during
transport. Please check the condition of the device immediately after receiving
it.
•
Please note that accident prevention regulations must be complied with.
Installation
•
The circuit is automatically switched off when the specified power is exceeded.
•
Before you connect the appliance, make sure that the information on the rating
plate of the appliance corresponds to the mains voltage.
•
The crepes device must be connected to the earth conductor of the power
supply.
Positioning
•
To avoid damaging the surfaces, carefully remove the packaging.
•
Remove the protective film from the exterior walls. Avoid sticking residues. In
case the adhesive remains behind, please remove it with a suitable solvent.
•
Place the appliance on a level, safe place that can withstand the weight of the
appliance.
•
Ensure that the cable is long enough to be pligged in.
•
Make sure the cable is undamaged and not pinched under the device.
•
Check that the cable is not in contact with sharp edges and / or hot surfaces.
•
The crepes device must be positioned so that maintenance can be carried out.
•
The devices are not suitable for installation.
•
Do not place the appliance near walls or other objects made of combustible
materials.
