TROUBLE! MATERIAL BEING SPRAYED IS SPLATTERING
WHAT’S WRONG?
WHAT TO DO…
Viscosity of material is too high.
Thin material per manufacturer recommendation.
TROUBLE! ATOMIZATION IS TOO COARSE
WHAT’S WRONG?
WHAT TO DO…
Viscosity of material too high.
Thin material per manufacturer recommendation.
Flow control knob setting too high
Decrease flow control setting
Material accumulated /clog inside nozzle
Clean
Air inlet blocked
Clean or change air filter
Canister loose
Screw canister tightly in place
Quick refill lid loose
Screw quick refill lid tight in place
TROUBLE! SPRAYER PULSATES.
WHAT’S WRONG?
WHAT TO DO…
Air filter clogged
Clean or change air filter
Material in canister almost empty.
Refill canister.
Canister loose
Screw canister tightly in place
Quick refill lid loose
Screw quick refill lid tight in place
TROUBLE! SPRAY MATERIAL DOES NOT COVER PROPERLY
WHAT’S WRONG?
WHAT TO DO…
Flow control knob setting too low.
Increase flow control setting
Clearance to target area too large
Reduce spray distance
Too few spray paths sprayed over target area
Apply more spray paths sprayed over target area
Viscosity of material too high.
Thin material per manufacturer recommendation.
ENGLISH
ENGLISH
Summary of Contents for NSG0070-US500
