M-Series System Configuration
40
432-0003-00-10 Rev 150 — M-Series Operator’s Manual
These power numbers assume a single JCU is plugged into the camera and
window heaters are not active. When heaters are active, additional power is
consumed based on single or dual payload:
•
For dual payload models, an additional 16 W is consumed for a maximum
power consumption of under 46 W.
•
For single payload models, an additional 6.5 W is consumed for a maximum
power consumption of under 26 W.
Note:
Window heaters are never active when the camera is in standby and high
power mode is disabled.
Enable (Disable) Rearview Mode
This menu entry enables or disables the rearview mode, which causes the video
image to be flipped horizontally (revert). The image on the display provides the
same perspective as a rear view mirror in a vehicle; objects off the stern on the
starboard side of the vessel are displayed on the right-hand side of the video.
When rearview mode is enabled, the rearview mirror icon is displayed on the
screen. You can configure the USER button to enable or disable Rearview Mode.
Set Stow Position
When Set Stow Position is selected, the camera stores the current position
(camera azimuth and elevation) as the stow position. The camera moves to the
stow position when it is turned off (put into standby mode). See “Standby Mode”
on page 25 for additional information about standby mode.
The stow position is not necessarily the same as the home position. The home
position is typically the position the camera will most likely be in when the camera
is in use, or a preferred reference position for the camera. The stow position is
the preferred position when the camera is not in use, for protecting the camera
optics. Both positions are programmable by the user.
Standby
High Power Mode OFF
High Torque Mode OFF
8 W
7.4 W
Awake
High Power Mode ON
High Torque Mode ON
30 W
19.4 W
Awake
High Power Mode OFF
High Torque Mode ON
30 W
19.4 W
Awake
High Power Mode ON
High Torque Mode OFF
21 W
16.5 W
Awake
High Power Mode OFF
High Torque Mode OFF
21 W
16.5 W
TABLE 4.2
Power Consumption
Camera State
Camera Setting
Dual Payload
Single Payload
www.netzerotools.com
www.netzerotools.com
