2
INSTALLATION
1. Turn OFF power to CPU and monitor(s).
2. Disconnect the monitor cable at the CPU and reconnect it to OUTPUT 1 on the rear of the VOPEX. OUTPUT 1
must
be
connected to a monitor for the unit to operate properly. It is labeled as such (see Fig. 1).
Note: If a monitor with DDC support will be used, it must be connected to OUTPUT-1. All other monitors must support
the highest video resolution supported by the DDC monitor connected to OUTPUT-1.
3. Install the 15HD male end of the NTI-supplied video interface cable into the CPU’s video output connector.
4. Install the 15HD female end of this cable into the INPUT connector of the VOPEX.
5. Additional monitors may be plugged into the remaining OUTPUT(s) as required.
6. Plug in VOPEX power cord and turn unit ON.
Note: VOPEX-xV-H-UL model does not have power switch. Just plug in AC adapter to power up.
7. Turn ON power to CPU and monitor(s).
Figure 1- Connect VOPEX to monitors and CPU
Existing Cable
Extension Cable
VEXT-THN--xx (optional)
VEXT-THN-3 (supplied)
OUTPUT 1
OUTPUT 2
INPUT
4
2
3
5
1
10
9
8
6
7
15
14
13
12
11
CPU
REAR VIEW OF VOPEX-2V-H
15HD male
Video Connector
15HD female
Video Connector
