1.
2.
3.
Endelig disponering av dette produktet må skje i henhold til nasjonlae lover og forskrifter.
A descartagem final deste produto deverá ser efectuada de acordo com os regulamentos e a legislacão nacional.
El desecho final de este producto debe realizarse según todas las leyes y regulaciones nacionales.
Slutlig kassering av denna produkt bör skötas i enlighet med landets alla lagar och föreskrifter.
UX1000 FCC and Industry Canada Compliance Statements
This section describes the requirements for compliance with Federal Communications Commission (FCC) Rules and Industry Canada CS-03 standard.
FCC Registration and Requirements
Service
FCC Rules, Part 15
FCC Rules, Part 68
Industry Canada - Equipment Attachment Limitations
Statement of Compliance
Ringer Equivalence Number (REN)
EMC Compliance Statement
FCC Registration and Requirements
The following paragraphs describe the requirements and information based on FCC rules.
Service
If you experience problem with the NET - UX1000 Unified Exchange products, contact NET Technical Support Center at 1-800-800-4638 for information
on service or repairs. The telephone company can ask you to disconnect the equipment from the network until the problem is corrected or until you are
sure that the equipment is not malfunctioning.
FCC Rules, Part 15
The NET - UX1000 Unified Exchange has been tested and complies with the limits for a class A digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the
user will be required to correct the interference in the user’s expense.
FCC Rules, Part 68
FCC Part 68 Registration
The UX1000 Unified Exchange complies with Part 68 of the FCC Rules and the requirements adopted by the Administrative Council of Terminal
Attachments (ACTA). On the back of this equipment is a label that contains, among other information, the ACTA labeling identification numbers
US:1BHISNANUX1000 and US:1BHIS04BUX1000. If requested, this information must be given to the telephone company.
Ringer Equivalence Number (REN)
The ringer equivalence number (REN) is used to determine the quantity of devices which may be connected to the telephone line. Excessive
RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all areas, the sum of RENs
should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact
the local telephone company.
Facility Interface Information
In order to connect registered terminal equipment to the telephone company lines, the terminal equipment must utilize FCC registered jacks.
Standardized jacks are used for this equipment.
