Separate the back plate from the transmitter and
decide on a suitable location to attach the receiver.
Position the back plate against the surface you which
to attach it to and mark out the position of the 6
screws. Use the appropriate drill bit for the surface
you are attaching it to and appropriate wall plugs.
Run a bead of waterproof sealant around the back of
the back plate before screwing in place to create a
waterproof seal.
Drill a hole through the wall, in the middle space of
the back plate, large enough to feed the supplied
1A bell cable through. Connect the external ends
of the bell cable to the AC/DC connections making
sure the bare wire is firmly held by the connectors
(the order does not matter).
Feed any excess cable through the hole and
place the transmitter onto the back plate, it will
slide into place and be flush with the back plate
when correctly positioned.
Screw the 2 small screws supplied into the base of
the transmitter using the supplied Allen key.
Connect the bell wire inside the house to the block
connector supplied using a screw driver. Make sure
the bare wire is firmly held in place by the screws.
Connect the block connector to the jack on the
included power adaptor. Plug the adaptor into a
grounded 3 pin socket and turn on. The external
transmitter is now ready.
Summary of Contents for VueBell
Page 3: ...Name of Parts...