Page 57 of 97
Title FireVu Detector Standalone Installation Manual
NetVu Ltd.
No 1 Thellow Heath Park, Northwich Road, Northwich, Cheshire. CW9 6JB
Click on Default (Green) to return the detector to factory default settings. Network Settings such as
IP address will not be affected.
Click on Reset (Red) to re-start the detector.
Features
The page is used to enable additional network ports on the detector
LLDP Operating Mode: Sets the current LLDP Operating Mode. The Link Layer Discovery Protocol
(LLDP) is a vendor-neutral link layer protocol used by network devices for advertising their identity,
capabilities, and neighbors on a local area network based on IEEE 802 technology, principally wired
Ethernet.
Secondary Web Port : If the primary web port is blocked by the firewall, it is possible to configure a
second port number here. The unit is then accessed using the IP address of the unit, followed by a
colon (:) and this port number.
RTSP TCP Port Selection: Use this option to change the TCP port number used by the RTSP server.
Max Client Connections: This limits the number of client connections to the server. It defaults to
256 but in heavy network traffic it is recommended that this value be increased. Please consult your
network administrator for appropriate settings if needed.
ARP Cache Size: This limits the number of cache entries available in the ARP table. It defaults to 256
which is adequate for most instances. Consult your network administrator for advice about whether
this should be increased.
