10
6.
Installation
1.
Use the attached 3M rubber pad, stick one side to the Wireless 2-
Gang Push Button (RB02B), and stick the other side to the wall.
2.
To make the installation firmer, please use screws (purchased
separately) to fix the device to the wall.
* Note:
Please don't stick it on the rough wall to avoid the device from
falling off after the long-term usage.
If use the supplied 3M rubber pad, please wipe the wall clean before
installation to avoid dust on the wall and affect the effect of the
paste.
The middle part of the 3M rubber pad (the part with the red frame in
the figure below) is where the label is attached to the device. Please
remove the rubber pad that has been cut.
Do not install the device in a metal shielded box or in an
environment surrounded by other electrical equipment to avoid
affecting the wireless transmission of the device.
3.Install the battery in the battery holder, and close the
snap-fit joint of the device.
*Note:
If user wants to open the snap-fit joint, user can pry it
gently.
RB02B can be applied to the following scenarios:
Home (bathroom)
School
Nursing home
Hospital
Bank
Hotel
The place where an emergency may occur.
3M Rubber Pad
Screw holes
Snap-fit Joint
