9
6. Installation
This product comes with waterproof function. When using it, the back of it can be adsorbed on the iron surface, or the two ends
can be fixed to the wall with screws.
Note: To install the battery, use a screwdriver or similar tool to assist in opening the battery cover.
1.
The
Wireless 2-Gang Water Leak Detector
(R718WA2) has a
built-in magnet (as Figure 1 below). When installed, it can be
attached to the surface of an object with iron which is convenient
and quick.
To make the installation more secure, use screws (purchased) to
secure the unit to a wall or other surface (as Figure 2 below).
Note: Do not install the device in a metal shielded box or in an
environment with other electrical equipment around it to avoid
affecting the wireless transmission of the device.
Wireless 2-Gang Water Leak Detector (R718WA2) could
be applied to the following scenarios:
⚫
Data center and engine room
⚫
Document storage center
⚫
Basement water leakage monitoring
⚫
Water pipe leakage detection
⚫
Bilge monitoring
The device is designed to detect water leakage and is not
suitable for detecting harmful chemicals, solvents, oils,
fuels, strong acids or other corrosive liquids.
2. Tear off the 3M glue at the bottom of the sensor probe and stick it
on the flat ground where water leakage may accumulate.
As shown in the enlarged picture on the right:
3. When the sensor probe detects water leakage, the water
leakage detector device will send "alarm" information.
Remove the probe from the accumulated water leakage
position, and dry the remaining water in the sensor.
The device returns to the "normal" state and sends the
"normal" state information.
*Take R718WA (single way) as the schematic diagram
