12
6. Installation
8. Installation
1.
Remove the 3M adhesive on the back of the
3-axis
Accelerometer Sensor and attach the body to the surface of a
smooth object (please do not stick it to a rough surface to
prevent the device from falling off after a long time use).
Note
：
Wipe the surface clean before installation to avoid dust on
the surface to affect the adhesion of the device.
Do not install the device in a metal shielded box or other
electrical equipment around it to avoid affecting the wireless
transmission of the device.
2. Installation Precautions
：
While installing, it is recommended to install R311FA1
horizontal while the generator is power-off and in static status.
After installing and fixing R311FA1, please turn on the device.
After the device is joined, one minute later, R311FA1 would
perform the calibration of the device (the device cannot be
moved after the calibration. If it needs to be moved, the device
needs to be turned off/powered off for 1 minute, and then the
calibration would be performed again). R311FA1 would need
some time to gather the data of three-axis accelerometer & the
temperature of the generator while it is working normally. The
data is a reference for the settings of ActiveThreshold &
InActiveThreshold, it is also for checking if the generator is
working abnormally.
3-axis Accelerometer Sensor (R311FA1) is suitable for the
following scenarios:
Industrial Equipment
Industrial Instrument
Medical Instruments
When it necessary to detect 3-axisthe acceleration and velocity
3.When R311FA1 detects the data of three-axis accelerometer
exceed ActiveThreshold, R311FA1 would report the data that
detected. After sending the data of three-axis accelerometer,
the data of three-axis accelerometer of the device needs to be
lower than InActiveThreshold and the duration has to be
more than 5 seconds (cannot be modified) before the next
detection.
Note
：
While the data of three-axis accelerometer of the device
is lower than InActiveThreshold and the duration has to be
lesser than 5 seconds, at this time, if the vibration continues
(the data of three-axis accelerometer is higher than
InActiveThreshold ), it will be delayed for 5 seconds. Until
the data of three-axis accelerometer is lower than
InActiveThreshold, and the duration is more than 5
seconds.
R311FA1 would send two packets, one is the data of
three-axis accelerometer, and the other would be sent after
10 seconds with the data of three-axis velocity.
