5
Sleeping Mode
The device is on and in the
network
Sleeping period: Min Interval.
When the reportchange exceeds setting value or the state changes: send a data report according
to Min Interval.
Low Voltage Warning
Low Voltage
2.4V
5. Data Report
Data report configuration and sending period are as following:
Min Interval
(Unit:second)
Max Interval
(Unit:second)
Reportable Change
Current Change
≥
Reportable Change
Current Change
＜
Reportable Change
Any number between
1~65535
Any number between
1~65535
Can not be 0.
Report
per Min Interval
Report
per Max Interval
When the device is turned on, it will immediately send a version package and an attribute report data.
The device sends data according to the default configuration before any other configuring.
Default setting:
Maximum time: 3600s
Minimum time: 3600s (Default: Every Min Interval will detect the state of the dry contact one time)
BatteryChange: 0x01 (0.1V)
(If there are special customized shipments, the settings will be changed according to customer’s requirement.)
R311DA trigger:
When the device senses vibration and the ball is shaken, an alarm message will be reported.
The shaking alarm bit is “1”.
The static and non-shaking alarm bit is “0”.
Restore Function:
There are two ways for the ball to trigger an alarm.
One is not to report the recovery status after sending the alarm.
(default)
The other is to report the recovery status after the device stops vibrating for 5 seconds after sending the alarm.
The two ways can be executed before shipment or by LoRaWan command configuration
Note:
The interval between two reports must be the MinTime.
The reported data is decoded by the Netvox LoRaWAN Application Command document and
