- 4 -
3. RAID Level Re-configuration
For re-configuring the RAID microprocessor, please
1.
Change RAID level
2.
Turn off power
3.
Turn on power
※
CAUTION: After changing the RAID level, HDDs will be
reconfigured on restarting the device.
4. AUTO-Rebuilding / Hard-Copy – RAID 1 support
only
Auto rebuilding can be applied for data security, which ensures the
data recover with AUTO rebuilding function, Hot-Copy features HDD
duplicating with or without host connection.
For hot-swapping,
1.
Remove one HDD from any of equipped subsystem without
shutting down the Operating System.
2.
Keep accessing with the HDD left, you’d hear the buzzer beeping
due to the missing HDD.
3.
Re-plug the removed HDD, then buzzer will stop beeping and you’ll
see the LED for HDD flashing while AUTO rebuilding.
For duplicating data to another disk,
1.
Ensure the subsystem is under RAID 1 mode.
2.
Ensure which HDD contains complete data and plug the HDD into
any bay of it first, before or after powering on.
3.
Ensure the firstly installed HDD has been recognized by
subsystem – the firstly installed HDD will be regarded as SOURCE.
Meanwhile, you’d hear the buzzer beeping due to the missing HDD.
4.
Plug another HDD into another drive bay - the newly installed HDD
will be regarded as DESTINATION
Then buzzer will stop beeping and you’ll see the LED for HDD
flashing while data duplicating.
